Saws Plan 
X
 
Transverse Reman Board Edger 
X
Infeed Transfer 
X
 
Positioning Infeed 
X
 
Saws Infeed 
X
 
Saws Outfeed 
X
 
Plan View 
X
 
Tailer 
X
 
Transverse Reman Board Edger - USNR:
 
Transverse Reman Board Edger
  • Board edger with feed speeds to 1,200 feet per minute
  • Piece counts to 36 pieces per minute on 20' lumber
  • Available with or without reman head
  • Transverse edger optimization
  • Improved lumber recovery
More ...
 
Infeed Transfer
  • The flitches are singulated by an unscrambler
  • At the top of the unscrambler, the flitches are even ended and loaded into lugs
  • Wane down boards are turned wane up by the board turner
  • The flitches are scanned on the lug chain with laser / camera profiling scanners
  • The scan data is then optimized with the edger optimizer to provide the highest value edging solution for each flitch
More ...
 
Positioning Infeed
  • The feed table centers the flitch using linear positioners based on the edger optimization solution
  • The pressrolls, in conjunction with the parking ramp hold the flitches after being centered
  • The parking ramp and pressrolls then drop allowing the board edger infeed chain to feed the flitch to the board edger
More ...
 
Saws Infeed
  • The board edger "edges" the flitches based on the optimum solution from the edger optimizer
  • The saws will slew on the arbor to the position required to edge the flitch
  • The outfeed pressrolls are sequenced down on the flitch to hold it in position
  • The top chipping head will remanufacture a nominal 2" board that is scant or has excess wane into a 1" board
More ...
 
Saws Outfeed
  • The board edger "edges" the flitches based on the optimum solution from the edger optimization system 
  • The saws will slew on the arbor to the position required to edge the flitch
  • The outfeed pressrolls are sequenced down on the flitch to hold it in position
  • The top chipping head will remanufacture a nominal 2" board that is scant or has excess wane into a 1" board
More ...
 
Plan View
  • The board edger "edges" the flitches based on the optimum solution from the edger optimizer 
  • The saws will slew on the arbor to the position required to edge the flitch
  • The outfeed pressrolls are sequenced down on the flitch to hold it in position
  • The top chipping head will remanufacture a nominal 2" board that is scant or has excess wane into a 1" board
More ...
 
Tailer
  • The board edger tailer fingers raise to the center of the sawn board(s) and lower for the tailings
  • Tailings fall into a waste conveyor below
More ...
 ©International Online Expos Inc. 2021Terms & ConditionsPrivacyContact Us