Saws Detail 
X
 
Linear Board Edger 
X
Scan Belt 
X
 
Infeed 
X
 
Outfeed 
X
 
Saws Detail 
X
 
Tailer 
X
 
Linear Board Edger - USNR:
 
Linear Board Edger
  • Linear (lineal) board edger with feed speeds to 1,200 feet per minute
  • Piece counts to 36 pieces per minute on 20' lumber
  • Available with or without reman head
  • Improved lumber recovery
More ...
 
Scan Belt
  • The flitches are singulated by an unscrambler
  • At the top of the unscrambler, the flitches are even ended and loaded into lugs
  • Wane down boards are turned wane up by the board turner (optional)
  • The flitches are scanned on the scan belt with laser / camera profiling scanners
  • The scan data is then optimized to provide the highest value edging solution for each flitch
More ...
 
Infeed
  • Chain bed holds flitch stable through the linear (lineal)
  • The pressrolls feed the flitch into the edger
  • Optional top reman head
More ...
 
Outfeed
  • The linear (lineal) board edger "edges" the flitches based on the optimum solution from the scanner
  • The saws will slew on the arbor to the position required to edge the flitch
  • The outfeed pressrolls are sequenced down on the flitch to hold it in position
  • The top chipping head will remanufacture a nominal 2" board that is scant or has excess wane into a 1" board
More ...
 
Saws Detail
  • The saws slew on the arbor to the position required to edge the flitch
  • The saws are skewed (angled) on the arbor based on the angle of the cut line
More ...
 
Tailer
The tailer fingers shift with linear positioners to the centre of the sawn board(s)
More ...